Direct Current Screw Pump 12V Stainless Steel for Deep Well Submersible Water Reservoir 30m Head

Feature: 1. FLOWRATE AND HEAD: This 12V deep well pump is a single eccentric screw pump with an elastic stator covering the screw. The working principle of the screw pump enables its maximum flowrate to up to 1.2m3h and the maximum head to up to 30 meters 2. POWER SUPPLY MODE: Only one 12V battery or battery pack, or one 300W solar panel is needed to drive this deep well pump. When the solar panels are directly connected to the pump, it is recommended to add an MPPT controller(not included) for better performance 3. OUTLET AND JOINTS: The package contains a 1in outer Diameter hook joint. Therefore, customers can choose to connect the deep well pump using NPT 34in threaded tubes or 1in inner Diameter hoses 4. ACCURATE MECHANICAL SEALING: The solar submersible well pump adopt a stainless steel body as a whole. The motor wire is made of copper, and the wire is made of quality rubber material with good insulation performance. The stainless steel spring and accurate bearings have high strength, good sealing, low resistor, durability, safety, environmental protecting, comfort, trusted operating and long service life 5. PENETRATION HOLES AND POWER CORDS: The deep well pump is equipped with two rope penetration holes, which facilitate users to insert or remove the pump from the well. The submersible screw pump is equipped with a 7 meter long copper conductor power cord, which is convenient for use in deeper wells Specification: Item Type: Direct Current Screw Pump Model: 3SYDC12VS1.230 Material: Stainless steel, cast iron, copper, rubber Flowrate: 1.2m3h Head: Approx. 30m 98.4ft Outlet: NPT 34in Equipped Outlet Fitting: NPT 1in Power Cord Length: Approx. 7m 23ft. Package List: 1 x Pump 1 x Water Outlet Joint 1 x User Manual Note: Please make sure the pump is completely covered in water before use to prevent damage caused by dry running.FLOWRATE AND HEAD: This 12V deep well pump is a single eccentric screw pump with an elastic stator covering the screw. The working principle of the screw pump enables its maximum flowrate to up to 1.2m3h and the maximum head to up to 30 meters POWER SUPPLY MODE: Only one 12V battery or battery pack, or one 300W solar panel is needed to drive this deep well pump. When the solar panels are directly connected to the pump, it is recommended to add an MPPT controller(not included) for better perfor OUTLET AND JOINTS: The package contains a 1in outer Diameter hook joint. Therefore, customers can choose to connect the deep well pump using NPT 34in threaded tubes or 1in inner Diameter hoses ACCURATE MECHANICAL SEALING: The solar submersible well pump adopt a stainless steel body as a whole. The motor wire is made of copper, and the wire is made of quality rubber material with good insulation performance. The stainless steel spring and accur PENETRATION HOLES AND POWER CORDS: The deep well pump is equipped with two rope penetration holes, which facilitate users to insert or remove the pump from the well. The submersible screw pump is equipped with a 7 meter long copper conductor power cord,