Yamazaki Jitsugyo Board Tweezers and Wood Screws Wall Projector Rack Black W10 X X H11cm Smart Wall Mounted Projector Stand Projector Holder 5898

*Please note that if the seller or shipper is outside of Japan, there is a risk that the product is a copy. Product size: Approx. W10 x D23.8 x H11cm ・Inner dimensions: Mounting part: Approx. W5 x D23.5 x H1.5cm Fixed screw mounting part: Approx. W1.3 x D19.5cm ・Load capacity: Approx. 3kg (Static load capacity assuming zero impact.) Quality display: Body: Steel (powder coating) Accessories: Projector fixing screws (1/4 inch x 11.3 mm, 1/4 inch x 18 mm) x 1 each, washers x 2, U-shaped parts x 1, gypsum board tweezers x 4, wood screws x 4, silicone seals x 3, hex wrench, notes: Assembly type, wall surface that can be mounted. When using gypsum board pins: Gypsum board such as wallpaper, cloth wallpaper, vinyl wallpaper, thin veneer When using wood screws: Pillars, board walls, printed plywood (where there is a horizontal sun on the back side) *Please read the compatible projectors carefully before purchasing to confirm whether it is compatible with your projector. *Please carefully read the instruction manual of your projector for the installation location and distance.・Compatible projectors: The fixing screw on the bottom must be a single hole type and compatible with 1/4 inch screws. (Please do not use a set screw conversion adapter, etc.) *If you are installing it horizontally, please check if your projector supports horizontal keystone correction. *The weight of the projector must be within 3kg. Compatible sizes: There must be no obstructions such as protrusions with a height of approximately 1 cm or more on the bottom of the projector. The screw fixing part on the bottom of the projector must be less than 1cm in height and 1.2cm in width. If there is a terminal connection cord, etc. on the back: A gap of approximately 10cm or more is required (the screw fixing part on the bottom from the back of the projector must be within about 11.5cm) If there is no terminal connection cord, etc. on the back: The screw fixing part on the bottom of the projector must fit within about 2.5-21.5cm from the back of the projector.