LWN Matek Systems Gnss M8q-can Electronic Component

Introductions: Product category:GNSS M8Q-CAN, UAVCAN & MSP description: Specifications ArduPilot AP_Periph F303 CAN node GPS SAM-M8Q (GPS, GLONASS, Galileo) Magnetic Compass QMC5883L Barometer DPS310 UART1, Firmware update UART2, onboard GPS UART3, MSP Protocol CAN, UAVCAN Protocol I2C, onboard QMC5883L & DPS310 I2C JST-GH connector, external AirSpeed sensor CAN bootloader LED, Blue Fast blinking,  Booting Slow blinking, working GPS PPS LED, Green blinking(1Hz) when GPS has 3D fixed Boot button Input voltage range: 4.5-5.5V (5V pad/pin) Power consumption: 100mA Operating Temperatures: -20-80 °C 29mm*29mm*9.7mm 11.3g Tips u-blox M8Q series has no external flash memory Compass Alignment(Arrow forward and flat mounting): Ardupilot/Mission Planner: Rotation None Make sure to have compass/magnetometer 10cm away from power lines/ESC/motors/iron based material The scratches on ceramic antenna are the result of tuning the antenna by ublox. HD cameras(Gopro, Split, Tarsier, etc) could interfere GPS signal, try turning off HD camera before GPS 3D fix Blue LED status can’t show communicating between CAN node and Flight Controllers since MSP was supported." Packing list: Matek Systems GNSS M8Q-CAN*1 Note:All images and descriptions are for illustrative purposes only. The color deviation is subject to actual system configuration and slight dimension difference is allowed due to manual measurement.